Long Bowl with Filtering End 14cm 18,8mm

Long Bowl with Filtering End 14cm 18,8mm

This model is intended for those who need a bowl-and-downstem assembly with clearly stated dimensions. The 14 cm length describes the component's size, while the 18,8 mm designation indicates the joint size that must match the bong's socket.

The product takes the form of an elongated tube with a filtering end. The bowl is part of this construction, so the model serves as a complete bowl-and-downstem assembly rather than two separately described accessories.

The 14 cm length determines where the component sits once installed in the bong. The filtering end is located at the tip of the downstem and directs flow into the chamber, following the operating principle of this type of water-filtered accessory.

Checking Fit: 14 cm and 18,8 mm

The 18,8 mm measurement refers to the joint, which must match the bong's socket. The 14 cm length is equally important: the component must fit inside the specific bong without its tip resting against the bottom or wall.

When inserting or removing the bowl, hold it close to the joint and avoid putting pressure on the long downstem. Remove buildup carefully to avoid placing mechanical stress on the filtering end or the connection to the bong.

• Match the socket to the 18,8 mm joint
• Allow for the full 14 cm length
• Do not press the tip against the bottom of the chamber

See Also

• CategoryDownstem with integrated bowl→